ADD-A-AMP INSTALLATION INSTRUCTIONS
Installation Instructions (Install time should be about 30-60 minutes):
GOAL: To install your aftermarket amp without having to cut or splice into your factory radio wire harness. Provides 4-channel rca outputs for your aftermarket amp and a amp turn on wire.
Step 1: Make sure and have your car off and key out of the ignition. After you have removed your factory radio you will need to identify the power/speaker harness on the back of your radio. There will be plugs in these connectors already installed. You will need to remove those plug(s) and set them aside for later in your installation. Remember to not pull them from the wires. Pull from the plug portion of the cable only.
Step 2: After you have removed the factory power/speaker plugs from the back of your radio you will need to connect the mating plugs from the vehicle specific harness (included with your order). This harness has male and female ends, once you connect this harness to the back of your factory radio you will then connect the factory power/speaker plug(s) that you removed in step 1 into the mating connectors on this harness. When finished all plugs will be used for your install.
Step 3: Connet the RCA's (there are 4 of them) to the rca's going to your aftermarket amplifier you are installing. This interface is capable of handing a 2 or 4-channel amplifier. If you are installing a 4-channel amp, then all four RCA's will be used. If you are installing a 2-channel amp then only 2 will be used. Put tape over the other 2 rca plugs to prevent any noise.
Step 4: Connect the remaining Blue wire to your aftermarket amp turn on. This will turn on your amp when you turn on your radio.
Step 5: Test everything to ensure installation is good before re-installing dash. Once everything is good re-install your dash and finish your amp install.
IF THESE DO NOT WORK FOR YOU, OR YOU NEED MORE INFO, PLEASE E-MAIL US AT SALES@INTEGRATIONSOLUTIONS.NET OR CALL US AT 214-306-8031